sungold power 300W Grid Tie Inverter For Wind System DC/AC Input 10.8V- 30V

This model grid­ tie has designed for wind turbines.The grid tie inverter can transfer wind energy from wind generators directly into the home grid using no extra equipment. It can be connected to any outlet (conventional network) in the home.The grid ­tie inverter controls the phase and the frequency and voltage of the power generated by the wind generator. It produces a pure sine wave and matches with the grid. There are 4 terminals on the left side of the inverter, 2 terminals will be connected to the DC output from the wind turbine, and 2 black terminals will be connected to dump load resistors.


Feature
Simple and safe installation
Low distortion output on all ranges
LED indicators to reflect power output rate
Stackable (connect in parallel for higher output)
Maximum Power Point Tracking (MPPT) - optimize power output
Plug and Play Design, simply plug into an outlet (GFI), no hard-wiring
Aluminum enclosure will act as heat sink to help dissipate heat
Island protection: Inverter will shut down during black outs.
Grid-Tied - sell green power directly back to the grid at a premium rate

Specification
Input DC Voltage Range : 10.8V ~ 30V
AC Output Continuous Power: 270W
AC Output Max. Power: 300W
AC Output Voltage Range: Switch at 230V Position 190V ~ 260V
Switch at 115V Position 90V ~ 130V
AC Output Frequency Range: 46Hz ~ 65Hz
Total Harmonic Distortion(THD): <5%
Power Factor: 0.99
Peak Inverter Efficiency: 0.92
Standby Power Consumption: <0.5W
Output Current Waveform: Pure Sine-wave
Recommend dump load resistor: 3 ohm/300w
Operating Temperature Range: -10 0C ~ 45 0C
Storage Temperature Range: -40 0C ~ 65 0C
Product Size/pc : 265 * 138 * 55mm
Package Size/pc: 295 * 190 * 100mm
N.W./pc: 1.7kgs
G.W./pc: 2kg