sungold power 1500W Peak 3000W DC to AC Stackable Power Inverter

It can convert DC Power to AC power. It can be widely used in vehicles, trains, vessels, solar energy and wind energy generating electricity, mobile office, tele communic- ations, police and other rush to deal with emergency situations. It is small size, less weight, and easy to use and causes less noise while working. It can be used parallel, and also can be used singly. The quantities of stackable power inverters in one parallel system can be composed freely in the range of 10pcs.

feature

There is whole protection and audio-visual alarm system in stackable power inverter. It can provide a full range of protection, mainly over-voltage protection, low-voltage alarm, under-voltage protection, over-heat protection, overload protection, short circuit protection, reverse polarity protection etc.

Installation Connections:

1. The Master/Slave switch MUST be set to MASTER. If the selection switch is set to the slave position, there will be no power output.
2. The positive and negative terminals on the inverter must be hooked to their respective positive and negative terminals on the battery. The larger the system the thicker the wires need to be. Use only appropriately rated fuse blocks or breakers inline with the positive cable. If you cannot feed the inverter with enough input power, then the output will be low or no output.
3. Switch on the inverter. If the LED indicator is green, it means the inverter is working properly. If the LED is red and you hear a beep, this means that the DC input voltage low or incorrect. Immediately turn off the inverter and check your connections.
4.Plug your appliance into the inverter, then switch the inverter on. A green light indicates that everything is working as it should. The inverter has soft-start function.
5.When in use if the alarm beeps the LED indicator will turn red, which means the inverter went into protection mode. Protection mode is an automatic shut down to help avoid damage from happening to the inverter. The number of beeps corresponds to a fault code, these inverters are smart as they tell you what is wrong. You can check the fault code in the