sun gold power Wind Charge Controller for 100W 200W 300W DC12V Wind Turbine Generator

Wind Charge Controller and Diversion Regulator Our charge controller will automatically disconnect your wind generator from your batteries when they are full and switch it to another load. This allows you to fully charge your batteries and then make use of the extra power. This form of regulation is required for wind turbines to always keep a load on the generator to prevent over-speeding. This microprocessor controlled charge/diversion regulator offers two charging modes, cycling mode for frequent use and non-cycling for stand-by power. Charging and discharging voltage levels can be default or user set. An optional fan may be connected that will be switched on while charging to remove any explosive gas from the battery enclosure. A relay protection feature prevents rapid, destructive switching of the relay. A heavy load setting bypasses cycling and the relay protection feature to allow quick response to accomodate heavy loads.

Feature

1. Automatic dump load while the wind turbine generator overload.
2. Batteries overcharge or over discharge protection.
3. Battery reverse connection protection, Lightning protection
4. Wind turbine current limiting, Wind turbine automatic brake and manual brake
5. Protect cable connect to batteries inverse.
6. Mini size, be easy to be install
7. Protect electric shock.
8. Water proof

Specification

MODEL: SG-WC300
System voltage: 12V
Rated power for wind turbine: 100W ~ 300W
Brake Start Voltage: 15V
Brake Recover Voltage: 13.5V
Brake Start Current: 15A
Display Model: LED
Output route: single way
Ambient temperature: -35 - +75 °c
Size: 96X76X21mm
Safe degree: IP67