robot arm of MINI-Pneumatic/Servo Beam Robot

MINI Pneumatic/Inverter/Servo Beam Robot for injection molding machine of QA850WD is applicable to all types of horizontal injection machine of 50~280T for take-out products and sprues.It can be added with sub arm for three-plate mold to clamp products and sprue at the same time. Its traverse axle can be driven by pneumatic cylinder, inverter motor or AC servo motor. After installed this robot, the productivity will be increased 20~30%, reduce defective rate, ensure safety of operators, reduce manpower and accurately control the output to reduce waste.
Structure:
Traverse axle can be driven by rodless cylinder or inverter motor, AC servo motor is optional. Vertical and Crosswise driven by pneumatic cylinder. Traverse axle and vertical arm are applied with advanced high rigidity linear slide rail, and light high rigidity alloy aluminum extrusion beam for Crosswise and Vertical axles. Integrating with linear guide and high rigidity bearing steel rod, it works with high speed, high efficiency, low vibration, and long use life.
Air Pressure Inspection:
Automatically detecting air pressure. It will alarm and display while pressure is not enough, and twitch anti-drop cylinder automatically to prevent the arm from dropping.
Controller:
Control box was combine with structure to save space. Palm controller with dialogue type operation interface, easy to operate, and the display language is changeable.
Built-in programs enable easy operation in molding change. With L/U take out function can be integrated with placing methods, swivel chosen, ejector setting and defect alarming, etc. Automatically defecting , displaying and recording the failures. Twenty groups of molding memorizing function.
Take out from fixed-mould side with various kinds of swivel actions. Different placing method (traverse-out, traverse-in, out-side and place at the same time) are available. All the Timer and Counter can be changed under AUTO MODE . Grouped PC board design facilitates changing and maintenance; Pay special attention to safety connection with I.M.M, all I.M.M input and output signals of are dry contacts signals to avoid interference.
With standard interface can be connected with Vertical Transporter or conveyor.
CE models are available, conformity with EUROMAP and SPI standard, enclosed standard connect interface.
Middle-Plate Inspection, Spray Device, Air Nipper and Safety Placing detecting are available to operated with automatic application of the factory.