liquid rubber

1)Rtv-2 Silicone application:

Rtv-2 Silicone for figurine and giftware casting (silicone rubber moldmaking)using polyester,polyresin,gypsum or plaster.

.



3)Rtv-2 Silicone pouring operation way:



1)Stir the base (Part A) well beofre use (except when depending on machine ).

2)Shake the catalyst container (Part B) well before use.

3)Weight the proper amount of catalyst into the container. Mix the base and catalyst thoroughly

4)Keep the mixture under full vacuum for 2-3 minutes.

5)Pour the deaired material slowly in a steady stream from one end of the mould so that the material flows evenly over the pattern.

6)Allow the rubber to cure for 2-4 hours at 250C before removing the cured rubber mold from the pattern. Heat acceleration not recommended with this product.