Small Hole Expanded Metal Mesh

Small Hole Expanded Metal Mesh
Punching Hole Mesh
Perforated Metal Ceiling Tiles
To my dear customer Dear Customer, Welcom to our website and hope our expanded metal mesh will make you satisfied. We think creatively, design bravely, manufacture precisely and loyalty to our customers. And we have our own factory. So we can produce the expanded metal mesh according to your requirements. We are looking forward to establisheing cooperation with you. Your SincerelyDongjie Product Description Expanded metal is an intermediate raw material that allows light and air to flow freely through it and that has more rigidity than the sheet from which it was produced. It is formed in an expanded metal press and produced from any malleable metal sheet product. The plate, sheet, or coil is simultaneously slit and stretched into diamond-shaped openings. These openings are of uniform size and regularity.
Regular (standard or raised) – all expanded metal is produced in regular form off the expanders. The strands and bonds are set at a uniform angle to the plane of the sheet. This gives added strength and rigidity, as well as a skid resistant surface.
Flattened – is manufactured by processing regular expanded metal in a rolling mill. The rolling process reduces the thickness of the original base metal.
Small Hole Expanded Metal Mesh
Materials * Carbon Steel   * Aluminum   * Stainless Steel  
* Galvanized     *  Copper       * Brass 
* Titanium        *Platinum       * Zinc   
* Nickel            * Silver          * Gold
Surface Treatments * hot-dip galvanizing     *pre-galvanizing
*anodizing, enameling   *power coating
*painting   *plastic coating, etc.
Hole Patterns *Diamond  *square
*round       *triangle    *scale
Benefits *The “Flow” of Light and Air 
*Design Customization
*Design Flexibility                
*Strength and Formability
*Durability  *Cost Effective    *Cost Effective
Design Designations
Strands – The sides of the expanded metal design 
Strand Thickness – Thickness of the base material from which the sheet was produced. 
Strand Width – Amount of metal fed under dies to produce one strand
Strand Thickness and Width – Can be varied to create different openings.
The width of the strand should equal or exceed the thickness of the base metal.
SWD – Nominal dimension, Short Way of Diamond 
LWD – Nominal dimension, Long Way of Diamond 
Design Size – Actual dimension SWD and LWD.
Measured from a point to a corresponding point on the adjacent diamond.
SWO – Short Way of Opening 
LWO – Long Way of Opening 
Bond – Where two strands intersect