SAE 50

1. IDENTIFICATION OF SUBSTANCE/PREPARATION AND COMPANY
Product Name: SAE 50 Engine Oil
Company Identification: Continental Oils and Lubricants FZE
Al Hamra, Ras Al Khaimah UAE. Po box 85637
Telephone: 00971-4-2981010 Fax: 00971-4-2365872
2. COMPOSITION / INFORMATION ON INGREDIENTS
Composition: SAE 50 Engine Oil
Chemical Nature: Petroleum derived refined solvent mineral base oil in which as measured by IP 346 is above 75%
Substance contributing to hazards: None to our knowledge in normal use
Impurities contributing to hazards: None to our knowledge in normal use
3. HAZARDS IDENTIFICATION
According to experience, product is considered to be harmless to health if handled correctly
4. FIRST & MEASURES
General Information: Remove contaminated clothing immediately, to be disposed of or washed before reuse.
Inhalation: If inhaled, provide fresh air, warmth, rest and medical advice if necessary.
Skin Contact: Clean areas of skin affected with soap and copious water. If necessary seek medical advice.
Eye Contact: In case of contact with eyes, rinse immediately with plenty of water until irritation subsides.
Ingestion: Allow the patient to vomit on his own accord. Give copious water to drink and seek medical help if necessary.
5. FIRE FIGTING MEASURES
Extinguishing Media: To suit local surroundings (e.g. water spray, carbon dioxide foam, chemical powder).



MATERIAL SAFETY DATA SHEET
Special Exposure: Hazard Decomposition products released in a fire should be considered as probably harmful if inhale (refer to Stability and Reactivity section).
Protective Equipment: Wear self-contained breathing apparatus.
6. ACCIDENTAL RELEASE MEASURES
Methods for Cleaning up Take up with absorbent material, e.g. sand, sawdust and dispose of as prescribed.
Do not allow to get into waste water or waterways; if this occurs, inform the relevant authority at once.
7. HANDLING & STORAGE
Advice on Safe Handling: Handle in accordance with good hygiene and safety practice.
Avoid temperatures >65 C®
Advice on Protection against Fire & Explosion: N/A
Storage Conditions - Ensure adequate ventilation of storage area. Keep container tightly closed, cool (< 65C®) and dry
8. EXPOSURE CONTROLS / PERSONAL PROTECTION
Exposure Controls: Monitoring of the workplace should be considered in accordance with EH40 (or
equivalent) Controls. LTEL (8 hour TWA): 5 mg/m 3 (EH40, 1998) STEL (15 min): 10 mg/m 3 (EH40, 1998)
OES data for oil mist, mineral .In addition the Reciprocal Calculation Procedure (RCP) for hydrocarbons should be considered (EH40, 1998)
Engineering Controls: Ensure adequate ventilation of working area e.g. Local Exhaust Ventilation.
Personal Protection: Observe normal safety standards for handling chemicals. Avoid inhalation of vapor.
Avoid contact with skin and eyes. Wear personal protective equipment appropriate for the task e.g. gloves, safety goggles, respirators (e.g. if ventilation is inadequate), appropriate overalls.
9. PHYSICAL& CHEMICAL PROPERTIES

MATERIAL SAFETY DATA SHEET
10. STABILITY & REACTIVITY
Stability: N/A
Thermal Decomposition: Not determined\
Conditions to Avoid: N/A
Material To Avoid: N/A
Hazardous Reactions: The product does not undergo hazardous polymerization.
Hazardous Decomposition products: Oxides of carbon, aldehydes, ketones, and ofhydrogen sulphide plus combustion products of nitrogen and Sulphur.
11. TOXICOLOGICAL INFORMATION
Acute Toxicity No acute toxicological data are available.
LD 50 rat (oral): N/A
LD 50 rat (i.v.): N/A
Dermal Compatibility N/A
Mucous Membrane Compatibility: N/A
12. ECOLOGICAL INFORMATION
Eco toxicology: Eco toxicological data are not available.
Further Ecological Information: N/A
Further Information: The product must not enter ground or waste water. If this occurs, inform the local authority at once. Calcium content: approx. 0.229% by mass (atomic absorption)
13. DISPOSAL CONSIDERATIONS
Advice on Disposal: In accordance with national and local authority regulations, e.g. special waste or Incineration after consultation with the operators.
Contaminated Packaging: Treat emptied containers in the same way as the product, or if possible wash out thoroughly and recycle.