Processing and manufacturing of cone crusher

Crusher model:
КСД-900, КCД-1200, КCД-1750, КCД-2200
КМД-900, КМД-1200, КМД-1750, КМД-2200
Cone crusher mainly consists of frame, drive shaft, eccentric sleeve, spherical bearing, broken
It consists of a broken cone, adjusting device, adjusting sleeve, spring and cutting port.
During the working process of the cone crusher, the motor drives the eccentric sleeve to rotate by the transmission device, and the moving cone rotates under the eccentric bushing. The section of the moving cone close to the static cone becomes the crushing cavity, and the material is subjected to the moving cone and The static cone is crushed by multiple extrusions and impacts. When the moving cone leaves the section, the material that has been broken to the required particle size falls under its own gravity and is discharged from the bottom of the cone.
Pay attention when working
1, the feed size ratio is appropriate
2. Automatic control device;
3, the crusher discharge to pass
4. Correctly select the crushing chamber for the broken material.
5. Evenly distributed in the 360® range of the crushing chamber
6. The specifications of the conveyor belt are compatible with the maximum output capacity of the crusher;
7. Appropriate selection of sieve specifications for pre-screening and closed-screen screening.
+86 18642196671
*
Wechat:chaoyangrunxing