MB-MT Color Crack Adhesive (2 in 1)

Features:
1, this product is a new type strong adhesive,
2, the adhesive has certain thixotropic, can finish the adhesion and gap filling at the same time, convenient and save time
3, good water resistance function and anti-aging
4, environmental friendly, non-toxic
5, good anti-infiltration function
Surface Treatment:
1, the substrate surface should be firm, dry and clean, no grease, no wax, and other loose materials.
2, the substrate surface should has certain firmness, and requiring basic smooth and vertical rate
Operation Process:
1, the ratio: MB general tile adhesive: water: 3.3: 1mixed and stirred into paste, put it aside for a few minutes and then a little stirring to gain the better effect
2, using tooth scraper to scrap the adhesive onto the surface evenly, control within 1m2, then scrap the adhesive on the backside of paper ceramic tile or mosaics, then adhere the mosaics on the surface and pat evenly.
Technical Reference:
Coverage area(amount) Technical reference
1, coverage area differs according to the circumstance
adjust time (min)
≥5
2, using 3*3mm tooth scraper about 1.5-1.8kg/m2 cool time (min) ≥10
dry time about 2h
container status white uniform powder
stretch rate ≤0.50
all the above amount are based on the smooth surface according to JC/T547-94
(ceramic tile adhesive industry standards) standard connection shear strength ≥1.0MPa
water shear strength ≥0.7MPa
temperature shear strength ≥0.7MPa
freeze-thaw shear strength ≥0.7MPa
Cautions:
1, check the situation of the surface before operation
2, operating under 5℃~40℃ situation
3, during summer, above 40℃, cooling the surface, so as to avoid the influence by the loosing water
4, never mix the dry slurry with water and use again
5, finished after 24h, can be make the next process
Store Method:
Store in cool and dry place, unopened product can be saved for one year.
Packing:
25kg/bag, 5kg/bag