LED Flashlight for Automobile

Features:
1. The main illumination part is consisted of ? white LED(3 pcs). intensity >9000mcd
2. The sidelight is consisted of ? red LED(6 pcs), which can be used as caution light. Its wink frequency is 9~11Hz
3. Alarm: 85db
4. The hammer can scrap the windowpane in emergent circumstance for safe esacpe.
5. The sharp knife can cut off the lap-belt in emergency.
6. The embedded magnet componet at the end enables this flashlight to be absorbed to any metal part.
7. Handling rope makes it convenient for taking.
8. Waterproof design makes it applied in bad weather.


Instructions:

1. battery installation (or battery replacement)
a) wind the cover (at the end with hidden cover) anticlockwise then take it off.
b) Prepare 3 pcs of AA batteries,then fit them into the flaslight?s body,make sure the positive pole towards inside,finally screw the cover colockwise and tightly.
Attention please: 3 pcs of AA rechargeable batteries are suitable as well.
2. The main illumination part is consisted of 3 pcs of high bright LED. They could be lighten up if you press the former red button on the top of the flashlight.
3. Caution Light
Press the later red button on the top surface then the caution light will work.
If you want to stop it, please press this button continuously for three times.
4. Alarm Whistle
Open: Press the former button twice continuously
Close: Press the same button twice continuously
5. Alarm Whistle and Caution Light work at the same time
Open: Press the former button three times continuously
Close: Press the button just one time
6. Scrap windowpane
Please take off the red cover of the hammer before using it.