Chute feeder

Introduction
The chute feeder can be installed on the ground or hoisted on the discharge port of ore bin. The chute bottom plates do the reciprocating movement.

Features
Stroke can be adjusted by the eccentric wheel; the eccentric throw is half as big as the stroke. According to experience of some mine sites, the eccentric throw should be no less than 30mm for cohesive ore. The chute width is 2-2.5 times bigger than the maximum feeding granularity. The biggest chute feeder can supply ore with granularity less than 500mm.
Application
The chute Feeder is used to convey mineral lump from storage silo to equipment in industries like smelting, mining, chemical, building material, concentrating and coal, etc.
Working principle
The machine is usually installed underneath the discharging opening of ore bin. Minerals fall on the bushing. The bushing is located at the chute bottom, configured on idler wheel and via eccentric device connected with reducer which is linked to electric motor by coupler. When it works, electric motor drives reducer via coupler; eccentric disk and drain cap which is situated between chute frame bottom and roller begin to do reciprocal and linear motion so as to uniformly feed minerals.
Technical parameters
Model Outlet dimensionsW×H(mm) Max feed
particle size(mm) Feed
capacity(t/h) Motor model Motor
power(kw) weight(kg)
CG300×300 300×300 50 10--20 Y90L- 4 1. 5 265
CG400×400 400×400 100 10--30 Y112M- 6 2. 2 535
CG600×500 600×500 200 10--50 Y112M- 4 4 1045
CG700×500 700×500 250 10--60 1100
CG1240×980 1240×980 350 36--90 Y160M- 6 7. 5 1710
http://www.ytxinhai.com/en/
http://www.xinhaimining.com/en/