Botulax 50unit 100unit 200unit Botulinum Toxin Type A Original from Original Country South Korea

IMPORTANT:
Botulax is a complete analog of Botox keeping the same quality for a low price! Manufactured under the stringent GMP standards.
Botulax 100U Each vial contains
Active ingredient: Clostridium botulinum toxin type A (Strain: Clostridium botulinum CBFC26) (attached specifications) 10Ounits(U)*
Stabilizer: Human serum albumin (Korean Minimum Requirements for Biological Products) 0.5mg
Tonic adjuster: Sodium chloride (KP) 0.9mg
Description
It appears as a lyophilized white powder for injection in a colorless transparent vial and should become colorless transparent liquid when the diluent (physiological saline) is added.

Indication
It is indicated for the treatment of benign essential blepharospasm in patients 18 years of age and above.

Dosage & Administration
For blepharospasm, reconstituted BOTULAX© 50/100/200 (see Dilution Table) is injected using a sterile. 27-30 gauge needle without electromyographic guidance. The initial recommended dose is 1.25-2.5U (0.05mL to 0.1 mL volume at each site) injected into the medial and lateral pre-tarsal orbicularis oculi of the upper lid and into the lateral pre-tarsal orbicularis oculi of the lower lid. In general, the initial effect of the injections is seen within three days and reaches a peak at one to two weeks post-treatment. Each treatment lasts approximately three months, following which the procedure can be repeated. At repeat treatment sessions, the dose may be increased up to two-fold if the response from the initial treatment is considered insufficient-usually defined as an effect that does not last longer than two months. However there appears to be little benefit obtainable from injecting more than 5.0U per site. Some tolerance may be found when the drug is used in treating blepharospasm if treatments are given any more frequently than every three months, and is rare to have the effect be permanent. The cumulative dose of BOTULAX© 50/100/200 treatment in a 30-day period should not exceed 200U.

Dilution Technique
Prior to injection, reconstitute freeze-dried BOTULAX© 50/100/200 with sterile normal saline without a preservative. 0.9% Sodium Chloride Injection is the recommended diluent. Draw up the proper amount of diluent in the appropriate size syringe. Since the drug is denatured by bubbling or similar violent agitation, the diluent should be injected gently into the vial. Discard the vial if a vacuum does not pull the diluent into the vial. Record the date and time of reconstitution on the space on the label. BOTULAX© 50/100/200 should be administered within 24 hours after reconstitution. During this time period, reconstituted BOTULAX© 50/100/200 should be stored in a refrigerator (2-8«C).