Automotive Interior Materials Droplet Characteristics Tester

Introduction
Automotive interior materials droplet characteristics tester determine the materials’ droplet properties according to ECE R118 Appendix 7. This mechanical and electrical control tester is suitable for measuring the melting state of automotive interior materials in the specified radiation heat radiation.

Application
It’s used to evaluate the melt dripping and burning performance for hot melt materials under the main heat source.

Standards
1. 1995L0028-EN-01.01.2007-002.001-25 ( ANNEX V) Measurement method of melting properties.
2. NF P92-505 Dripping test with electrical radiator, used for melting materials.
3. EU 95/28/EC European parliament and of the council of 24 October 1995 relating to the burning behavior of materials used in the interior construction of certain categories of motor vehicle.


Technical Parameter
Items Parameters
Power output of radiation heat source 500W
Radiating surface of radiation heat source Transparent glass plate, Φ (100 ¯ 5) mm
Sample support: Φ118mm stainless steel ring with φ0.70mm, 2.10mm mesh stainless steel mesh in it.
residue container Inner diameter 118mm, depth 12mm
Sample size 70×70(mm), The thickness is no more than 13 mm
Distance from residue container to the sample rack 300mm
The range of heat flux meter 10W/cm2
working power supply AC220V, 50Hz, ≤1000W
The distance from the surface of the specimen to the surface of the radiation source 30mm
Dimension (Wide) 1120mm×(Depth)520mm×(Height)1250mm, vent hole Φ 100mm