4812 Channel Receiver

YTL channel receivers receives wireless signals from YTL wireless sensors and switches and provide 4 or 8 or 12relay outputs.


The connection from the receiver to actuator (relay case) uses network Cat 5 cable. 4 or 8 or 12 lighting circuits can be controlled by the receiver. Multiple receiver scan form a control network using CAN-Bus system. Computers can also be connected to the control network to query information from the receivers or send control commands to them. In this way, a centralized control can be implemented. Receivers may be installed above ceiling or inside electricity distribution box. There are 2 buttons on a receiver, one is used to make the receiver go into learning mode, and the other is used to clean up the learned information. It has the following characteristics:

Each receiver has a separate microprocessor, is the most advanced distributed control system.

Various switching modes are supported, such as delay on/off

The receiver has various control logic built in. Besides lights, it also can provide controls devices like curtain and HAVC.

1.1 Benefits